1/4"
Showing all 12 results
-
1/4″ Bulkhead | #80-2110
$27.001/4″ Bulkhead | #80-2110
$27.001/4″ bulkhead fitting. 1/4″ Swagelok compression fittings on each end.
Quick View -
1/4″ Nut & Ferrule Set | #80-2141
$7.00Quick View -
1/4″ Nut, Speedbite | #80-6186
$14.001/4″ Nut, Speedbite | #80-6186
$14.00Speedbite nut for 1/4″ SS tubing. Requires P/N 80-6185 for complete fitting assembly.
Quick View -
Ball Valve, 1/4″, SK Series | #80-2310
$239.00Quick View -
Cap, 1/4″ | #80-2237
$9.00Quick View -
Connection Sleeve, 1/4″, Speedbite | #80-6185
$9.00Connection Sleeve, 1/4″, Speedbite | #80-6185
$9.00Speedbite connection sleeve for 1/4″ SS tubing. P/N 80-6186 also required for complete fitting assembly.
Quick View -
FTG Connector, Male, 1/4″ Tube fitting x 1/4″ MNPT | #80-2121
$12.00FTG Connector, Male, 1/4″ Tube fitting x 1/4″ MNPT | #80-2121
$12.00FTG Connector, Male 1/4″T – 1/4″MNPT
Quick View -
FTG Connector, Male, 1/4″T-3/8″, MNPT |#80-2158
$16.00FTG Connector, Male, 1/4″T-3/8″, MNPT |#80-2158
$16.00This fitting was typically used to interface between 3/8″ NPT threaded extractor caps and 1/4″ tubing. Most newer 140 models (~2019+) do not require this part (see speedbite fittings). Take care installing this new part. Make sure the threads are started by hand before using a wrench to tighten.
Quick View -
Rebuild Kit for 1/4″ SK Ball Valve | #80-2339
$111.00Rebuild Kit for 1/4″ SK Ball Valve | #80-2339
$111.00Repair kit to repair a single 1/4″ SK Ball Valve
Quick View -
Set Screw for 1/4″ pneumatic valves | #80-2332
$7.00Set Screw for 1/4″ pneumatic valves | #80-2332
$7.001 set screw for chuck and valve stem on the 1/4″ pneumatic ball valve.
Quick View -
Tube Brush, 1/4″ | #80-9024
$4.00Quick View -
Union fitting, 1/4″, Swagelok | #80-2109
$17.00Union fitting, 1/4″, Swagelok | #80-2109
$17.00This fitting is used for connecting two sections of 1/4″ OD swagelok tubing.
Quick View